Extensometers
Clip-on Extensometer
Overview：NOTE: It is recommended that for measurement of yield and proof strength parameters Le should span as much of the parallel length of the test piece as possible. Ideally, as a minimum, Le should be greater than 0.50 Lo but less than approximately 0.9 Lc. This should ensure that the extensometer detects all yielding events that occur in the test piece. It is further recommended that for measurement of parameters "at“ or "after“ maximum force, Le is approximately equal to Lo.(ISO 6892)
Descriptions
Extensometer Gauge length(Le): 25mm/50mm/100mm;
Percentage extension range: 10/20/50%;
Accuracy: 0.03%
Attribution
Extensometer Gauge length(Le): 25mm/50mm/100mm;
Percentage extension range: 10/20/50%;
Accuracy: 0.03%
Products
Home
About Us
Products
Accessories
Stories
Solutions
